PSK31


We are searching data for your request:

Forums and discussions:
Manuals and reference books:
Data from registers:
Wait the end of the search in all databases.
Upon completion, a link will appear to access the found materials.

PSK31 is a digital mode used on the amateur radio bands. It derives its name from the fact that it uses phase shift keying, PSK rather than frequency shift keying, and it transmits data at a rate of 31 baud.

PSK31 is aimed at providing a greater level of performance for keyboard-to-keyboard, conversational-style data communications than is available with other data modes. This makes it a particularly attractive form of communications for radio amateurs.

The aim is to provide an efficient yet straightforward system which does not use the complicated ARQ processes, and with only enough error correction to match the typical error rates that are encountered.

Also, by using phase shift keying and a low data rate, it is possible to narrow the bandwidth, which considerably reduces the effects of interference and noise. Bandwidths of 31Hz can be used, making this an extremely narrow-band mode, and one capable of operating under severe conditions.

PSK31 basics

PSK31 is widely used, particularly on the HF amateur radio bands where its up to date features enable it to offer advantages over modes such as RTTY. It incorporates error correction techniques along with the use of a full ASCII and ANSI character set which enables it to fit in with modern day computer and telecommunications technology.

PSK31 uses a form of modulation known as phase shift keying, PSK. This is rather different to the frequency shift keying that is used for modes such as RTTY. PSK involves reversing the polarity, or phase, of the signal (180° phase shifts), and has been likened to reversing or swapping over the two wires in an antenna connection. However, in reality the phase reversals are not achieved in this way; instead they are generated and detected in the audio sections of the SSB transceiver being used.

There are various forms of PSK and the form of PSK described is actually known as binary phase shift keying, BPSK and it is more efficient than either frequency shift keying, which has a greater bandwidth, or on/off keying which does not use the power as efficiently.

PSK31 uses a novel form of data encoding. When sending asynchronous ASCII data, systems use a fixed number of data bits as well as start and stop bits. However, when sending a long run of data it is possible for the receiver to lose synchronisation. Additionally, improvements in speed can be gained from adopting variable-length codes with those codes that are used most often being the shortest. This is used to good advantage in Morse where the character 'e' (which is the most common in English) is a single dot. By analysing the occurrence of different ASCII characters a code called Varicode was devised. The shortest code, '00', was allocated to the space between two words.

It is possible to add error correction to the system. However, to achieve this it is necessary to use a form of keying called quadrature phase shift keying, QPSK.

Instead of two phase states 180° from one another, QPSK uses four phase states, each 90° from one another. However, in operation on the bands it has been found that error correction with the use of QPSK only sometimes gives improvements over ordinary BPSK. Accordingly it is possible to use either system, dependent upon the conditions.

PSK31 frequencies on HF bands

To enable radio amateurs to be able to keep to band plans and also to have contacts with other PSK31 users, certain frequencies tend to be used.

The frequencies detailed in the table of HF band frequencies give the frequency of the transceiver readout that should be used to provide the required signal frequency.

PSK 31 HF Frequencies
Amateur BandUpper Sideband
Dial Frequency
160 metres1838.150 kHz
80 metres3580.150 kHz
40 metres7040 kHz
30 metres10142.150 kHz
20 metres14070.150 kHz
17 metres18100.150 kHz
15 metres21080.150 kHz
12 metres24920.150 kHz
10 metres28120.150 kHz

Abbreviations used on PSK31

Many of the abbreviations and terminology used in PSK31 have been adopted from those used for Morse contacts.

For many people who have used Morse before, these terms will not be new, but for those who have come straight to PSK31 they may be new.

A list of some of the more commonly used terms and abbreviations are given in the table below.

Abbreviations commonly used on PSK 31
AbbreviationMeaning
KInvitation for the other station to transmit ( similar to "over" when using voice communications.
KNInvitation for a particular station to transmit
VAUsed at the end of a contact. It means that you have finished transmitting to the other station
BTUBack to you
TNXThanks
PSEPlease
OMUsed to refer to the other operator (when he is male). One tends to be a little more polite when talking to ladies.
FBFine business - indicates that a transmission has been received well, etc.
GMGood morning
GAGood afternoon
GEGood evening

Summary of PSK31 characteristics

Some of the highlight characteristics and parameters for PSK31 are summarised in the table below.


PSK31 Summary
ParameterDetails
Symbol rate21.25 baud
Typing speed~35 wpm
Bandwidth60 Hz
ITU description60H0J2B


Watch the video: PSK31 Demo (May 2022).